|
JBL BPX1100.1
1100 Watt Parallel/Bridge Subwoofer Amplifier for the ultimate configuration flexibility
Unlike conventional mono subwoofer amplifiers that only deliver their maximum power into a single impedance, the BPX1100.1 and BPX2200.1 are two-channel amplifiers that can be bridged to deliver double the voltage of a single channel into impedances between 2 and 4 ohms. The two channels can also be connected in parallel - that's right, parallel - to provide double the current of single channel into impedance below 2 ohms. This feature is patented and unprecidented in car audio amplification. Thanks Crown!
Slope-selectable variable electronic crossovers - Both the BPX1100.1 and BPX2200.1 is equipped with a variable electronic crossover capable of setting the slope rate at 12dB or 24dB per octave. The crossover adjustment range is 32Hz - 320Hz.
Dynamic Bass Optimization (DBO) - This provides variable filtering with adjustable "Q" below 100Hz, far beyond conventional "Bass Q" circuits, by allowing the low-frequency output to be optimized for specific subwoofer applications. Frequencies below an enclosure''s tunign frequency can be attenuated, preventing damage to the subwoofer and allowing the amplifier's power to be better utilized.
High Effective Damping Factor - Both the BPX1100.1 and BPX2200.1 have a high Effective Damping Factor. The result is better subwoofer control and lower distortion.
Both the BPX1100.1 and BPX2200.1 come equipped with a remote bass level control allowing you to optimize bass output for specific music or preferences from the driver's position.
Full-range preamp outputs - In the event that multiple amplifiers are used in an application, this feature allows for streamlined system hookup. No high-loss Y-adapters or splitteres needed.
- 1100W x 1 into 2 ohms
- 1100W x 1 into 4 ohms, series-bridged
- 1100W x 1 into 1 ohm, parallel-bridged
- Max Power : 2200W Peak
- Signal-to-Noise Ratio : >93dB
- Total Harmonic Distortion : 0.5%
- Frequency Response : 10Hz - 200Hz +0dB, -3dB
- Built-in variable electronic crossover with selectable slope
- Dynamic Bass Optimization (DBO) circuit
- Preamp outputs
- Differential inputs
- High damping factor
- Internal-lighting-ready
- Direct-Connect
- Remote level control included
- Dimensions (H x W x D) : 17" x 12-1/4" x 2-9/16"
|
